Trim or Extend Lines

Trim and Extend Tools

Clean up your work by removing gaps between lines and trimming off unwanted parts of lines

  1. Trim unwanted end parts of a segment
  2. Extend two segments together

 

 

trim_and_extnd.jpeg

Trim

Trim will remove unwanted end parts of a segment, beyond where two segment connect. To trim create a path by dragging your finger across the object you want to trim.

Note – You can trim more than one object at a time

 

Extend

Extend to connect/bring two segment together.

Do so by dragging your finger across both segments you want to connect.

While the video below shows an older version of trim and extend where they were available from the same mode, the actual trim and extend behaviors are still the same.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section

See more
Ask The Community
You can get support that’s tailored to you, owner exclusives and more
Create a Ticket
Get technical help in our ticketed support system.